Загрузил Gena Novokhatskiy

Additional instruction to the WO-2021-032

реклама
Additional instruction to the WO-2021-032
1. Set the value of the “Reversion mode enabled” to “Yes” (Fig. 1) in Screen layout setup.
Fig. 1
2. Check software version on PFD and EMS screens (left and right), - Fig. 2. If the software version earlier
than 16.0.2.8176, then upload to each screen the latest version from here SkyView/SkyView16.0.2.8176-dynon_update_HDX1100.dup
Fig. 2
3. Perform SkyView network setup according to SkyView_System_Installation_Guide-Rev_AI_v16.pdf
p. 4-18 to 4-21.
4. Upload to the PFD (left) screen following files, attached to the email:
 AF34000000_20_Sensor.sfg
 AF34000002_21_912 iS.dfg
 AF34000003_20_PFD.dfg
 AF34000005_20_AP.dfg
 AF34000006_20_basic_settings.dfg - !!! Please note, the file was updated, replace on the
USB previous version, the row inside changed to "gmeter_neg_red=-2"
 AF34000007_20_V-speeds.dfg
 AF34000010_20_units 3.dfg
5. Upload to the EMS (right) screen following files, attached to the email:
 AF34000000_20_Sensor.sfg
 AF34000002_21_912 iS.dfg
 AF34000004_20_EMS.dfg
 AF34000005_20_AP.dfg
 AF34000006_20_basic_settings.dfg - !!! Please note, the file was updated, replace on the
USB previous version, the row inside changed to "gmeter_neg_red=-2"
 AF34000007_20_V-speeds.dfg
 AF34000010_20_units 3.dfg
6. Check that layout of the PFD and EMS (left and right) screens corresponds to the layout options
shown on the Fig. 3 and Fig .4. It must NOT be possible to show on both screens only PFD
information, or only EMS information. Also try to switch OFF EMS screen and double check that on
the part of PFD (left) screen shown engine data, and vice versa – switch OFF PFD screen and check
that on the part of EMS (right) screen shown flight/navigation data.
Fig. 3
Fig. 4
7. After setup make a screenshot of PFD page in Six-Pack mode. This is necessary for us to check
V-speeds limits settings.
Fig. 5
Скачать