Viking craft, Norway: Assembly Instructions Canon ® is a registered trademark of Canon Inc. © Canon Inc. © Y.Watanabe Indicates where sections should be glued together. Before starting assembly:Writing the number of each section on its back side before cutting out the sections is highly recommended. (* This way, you can be sure which section is which even after cutting out the sections.) http://www.canon.com/c-park/en/ Indicates sections that should be glued first, then cut out. 3 2 1 1-3 View of completed model Viking craft, Norway Assembly Instructions The scourge of Europe from roughly the ninth through the 11th centuries, the Vikings and their fast, seaworthy vessels are said to have reached as far as North America around 500 years before Columbus. These craft were characterized by a single central mast about 20 meters high and a single sail. A partially preserved vessel has been discovered on the shores of Norway's Oslo Fjord. Mountain fold(dotted line) Make a mountain fold. Valley fold(dashed and dotted line) Make a valley fold. Scissors line(solid line) Cut along the line. Cut in line(solid line) *This model was designed for Papercraft and may differ from the original in some respects. Cut along the line. Parts list(pattern):Five A4 sheets(No.5 to No.9) No. of Parts:85 Tools and materials Glue The glue spot(colored dot) shows where to apply the glue. Glue spot(Red dot) Glue parts with the same number together. Glue spot(Green dot) Glue within the same part. Glue spot(Blue dot) Glue to the rear of the other part. Scissors, set square, glue(We recommend stick glue), pencil, used ballpoint pen, toothpicks, tweezers, (useful for handling small parts) *Build the model by carefully reading the Assembly Instructions, in the parts sheet page order. Assembly tip *Hint: Trace along the folds with a ruler and an exhausted (no ink) to get a sharper, easier fold. Caution 1 Before gluing, crease the paper along mountain fold and valley fold lines and make sure rounded sections are nice and stiff. Glue, scissors and other tools may be dangerous to young children so be sure to keep them out of the reach of young children. Viking craft, Norway: Assembly Instructions Canon ® is a registered trademark of Canon Inc. © Canon Inc. © Y.Watanabe 1-3 12 8 10 5 4 7 11 9 4-12 13-21 4-12 30 6 27 21 17 26 19 13 14 20 18 16 15 1-21 13-21 2 Viking craft, Norway: Assembly Instructions 22 Canon ® is a registered trademark of Canon Inc. © Canon Inc. © Y.Watanabe 23 24 25 Cut parts 33, 34, and 35 after folding them in two and gluing both sides together. 35 32 35 33 31 28 33 29 22-25+28+29 31+32 For parts 31+ 32, 33, and 34, glue six of each part in the locations indicated on both the left and right sides. 34 34 1-21+26+27+30 3 Viking craft, Norway: Assembly Instructions Canon ® is a registered trademark of Canon Inc. © Canon Inc. © Y.Watanabe 37 We recommend displaying the ship on the stand without gluing it to the stand. Cut part 36 after folding in two and gluing both sides together. 39 36 38 39 40 36+37 Finished! 4 Viking craft, Norway: Pattern Canon ® is a registered trademark of Canon Inc. © Canon Inc. © Y.Watanabe 1 2 3 5 Viking craft, Norway: Pattern 8 Canon ® is a registered trademark of Canon Inc. © Canon Inc. © Y.Watanabe 16 7 17 24 11 9 18 22 6 15 23 19 10 25 12 21 6 Viking craft, Norway: Pattern Canon ® is a registered trademark of Canon Inc. © Canon Inc. © Y.Watanabe 36 37 14 29 5 13 4 35 28 26 27 7 Viking craft, Norway: Pattern Canon ® is a registered trademark of Canon Inc. © Canon Inc. © Y.Watanabe 38 39 39 33 33 33 33 33 33 33 33 33 33 34 34 34 34 34 34 34 34 34 34 34 34 33 33 8 Viking craft, Norway: Pattern Canon ® is a registered trademark of Canon Inc. © Canon Inc. © Y.Watanabe 32 31 Norway Viking craft 32 40 31 32 CAUTION 31 Do not hit other people with the pointed edges. Doing so could result in injury. Adults should make sure that children observe this caution. 32 31 32 31 32 31 32 31 32 31 http://www.canon.com/c-park/en/ Canon ® is a registered trademark of Canon Inc. © Y.Watanabe 32 31 32 31 32 31 32 31 9
